A small and well-balanced floor loudspeaker, Tulip gives the listener the satisfaction of hearing a recording with studio or concert hall clarity and precision. Fully designed and built in Denmark. RETAIL: $4,000. Floor Sample (Walnut) $3499
PRICED PER PAIR
AVAILABLE IN BLACK ON ASH, WALNUT, OAK, WHITE ON ASH
Two Bass Drivers
With two powerful 6" woofers working in parallel, distortion is reduced for the low and mid frequencies. The total radiating area is actually larger than the 7" woofer used in Riva. A clean mid range reproduction is further more ensured through use of the same diaphragm compostion with natural fibers of the Riva and Ray mid driver.
For critical listening the grille is usually removed from the loudspeaker. By intergrating the grille into the design, this is no longer needed with the Tulip. Only 3mm thick, the sound is not at all blocked anymore by the grille. By fixing it to the cabinet, it is furthermore no longer a potential source of resonance.
The 24mm thick curved baffle is pressed into shape from 6 layers of High Density Fiber board (HDF). It provides optimal structural strength for the two powerful 6” woofers and the 1” tweeter. The cuts on the side enable the use of flat dowels to further strengthen the connection between the baffle and the cabinet walls.
Frequency response: 41 - 30.000 Hz
Impedance: 4 ohm, 3.3 ohm minimum at 41Hz
Sensitivity: 90 dB/2,83V/m
Max power: 100 W (IEC 268-5)
Woofer: 2x 6”, proprietary natural fibre cone. Extended copper sleeve on pole piece for low distortion. Xmax 20 mm peak-peak
Tweeter: 1", wide surround silk dome diaphragm
Cross over: 3,3 kHz. Bottom woofer 150 Hz low pass
System: Bass reflex
Cabinet: 6 layer beech wood form pressed veneer
Weight: 11 kg / piece