BLACK FINISH - LOCAL PICKUP ONLY!
8/10 CONDITION DUE TO AGE
HAS A BUILT-IN PHONOSTAGE AND COMES WITH AN ORTOFON 2M BLACK CARTRIDGE, SO YOU ARE SET TO PLUG AND PLAY INTO ANY SYSTEM!
An extremely lovely and well-built table from Shinola out of Detroit! Yes, the famed watch manufacturer's have put their fine craftship to use in our little world! They did a savvy thing and contracted a team of engineers in the hifi audio world to help them put together their dream table, and thus - it looks just as good as it sounds! Even more incredible - it comes with a lifetime warranty! It has a built-in phonostage, so you can directly connect it to any device or powered speakers!
The Runwell Turntable, designed inside and out for the discriminating audiophile and easy to use by any music enthusiast. Featuring a built in phono preamplifier and a belt driven pulley with speeds of 33 1/3 rpm and 45rpm.
Every component and element of the Shinola Runwell Turntable was carefully sourced from manufacturers across the globe, then built at our new Shinola Audio factory within our flagship Detroit store.
Wow and Flutter
< 0.1%
Gain
35.4db @ 1KHz
RIAA Conformance Deviation
Less than +/- 0.25db, 20Hz to 20 KHz, exclusive of infrasonic filter at 13Hz
Input Overload
> 200mv at 1KHz
Input Impedance
47kohm in parallel with 200pf
Signal-to-noise Ratio exclusive of cartridge intrinsic noise, unweighted
> 82db
Gain 1kHz MM
35.4dB (jumpers open)
Gain 1kHz MC
55.1dB (jumpers installed)
Termination impedance, MM gain resistive
47kohm, via synthetic cooled termination
Equivalent temperature of 47kohm input termination, midband
< 20 degrees Kelvin
Termination impedance, capacitive
200pF on board
Termination impedance, MC gain resistive
installed on input pads per cartridge requirements
EQ characteristic
RIAA standard
Infrasonic filter
Second-order maximally-flat, -3dBr at 13Hz
Line-level output resistance
49.9 ohms, unmated
Overload margins
> 32dB at any frequency from 20Hz to 20kHz, based on reference levels of 5mV rms at 1kHz, 500uV rms at 20Hz, 50mV rms at 20kHz
Output noise, MM gain, at various analyzer filter bandwidths and 75 ohm generator Z
22Hz to 22kHz: 22uV rms
100Hz to 22kHz: 12uV rms
400Hz to 22kHz: 8.6uV rms
Output noise, MC gain, 10 ohm generator Z
22Hz to 22kHz: < 220uV rms
100Hz to 22kHz: < 120uV rms
400Hz to 22kHz: < 86uV rms
Power consumption from mains input, preamp only enabled
< 8W
Distortion at noise-versus-distortion inflection point
< 0.001%
Dimensions
18” x 13.875” x 7.5” (47.6cm x 35.2cm x 19cm)